Guide · Manufacturer
How do dealers miss a manufacturer bonus by a few points, and how can you see it coming?
Many manufacturer bonus schemes pay in steps. Fall just below a threshold and you can lose that payment completely, not just a little of it. This guide explains how that happens, and how to see it in time to act.
The short answer
- Write down every element of your bonus scheme, with its threshold and what it pays.
- Check where you stand on each one every week, not at the end of the quarter.
- Work out where you will finish if nothing changes.
- Act first where you are closest to a threshold: a small push there protects the most money.
- Keep each version of the scheme with its dates, so any past period can be checked.
Why it happens
- A scheme has several parts, such as sales volume, parts purchases, customer satisfaction and standards. Each has its own target.
- Some parts pay nothing at all below a threshold. Missing by one point can cost the whole payment for that part.
- The manufacturer's statement often arrives weeks after the period ends, when it is too late to change anything.
- Each target sits with a different manager, so nobody sees the total at risk.
- One problem can hit two targets. Parts the manufacturer cannot deliver lower your parts purchases and, through longer waits, your satisfaction score too.
The warning signs
- An element is a few points below its threshold with only weeks of the period left.
- Satisfaction is falling while the scheme has a satisfaction condition.
- Parts purchases are behind target because orders cannot be filled.
- Nobody can say today how much bonus is at risk this quarter.
How to do it, step by step
1. Put the scheme in one place
List each element, its threshold, its steps and what each step pays. Note the dates each version of the rules applies.
2. Use your own figures, weekly
Take your own sales, parts and survey data each week rather than waiting for the manufacturer's statement.
3. Project the finish
At the current pace, where will each element end the period?
4. Put a money figure on each gap
"Three points short of the threshold, worth this much" gets attention. A percentage on its own does not.
5. Give each gap an owner
The sales manager, the parts manager or the aftersales manager, with the figure they need to reach.
6. Check again every week
Keep going until the period closes. A gap that closes early can free the team for the next one.
Illustrative figures only
An example
A dealer's parts purchases are running at 87% of target with five weeks of the quarter left.
- The scheme pays nothing for parts below 90% of target.
- At the current pace, the dealer will finish at 88%.
- That means the whole parts payment for the quarter is lost, not two points of it.
Seen with five weeks to go, closing three points is a clear task for the parts manager. Seen on the statement six weeks after the quarter, it is simply a loss.
Common mistakes
- Waiting for the manufacturer's statement to find out.
- Tracking only the total bonus, not each element.
- Calling a gap small because the percentage is small, without working out the money.
- Throwing away old versions of the scheme, so past periods cannot be checked.
Where Orion fits
Orion's manufacturer specialist holds your bonus scheme as dated settings, checks your position on each element as your data arrives, and puts a money figure on what is at risk.
The morning briefing then says which threshold is close and who should act. It works for a single site with one brand, and for groups with many.